Table of Contents
Advertisement
JR
VACUUM FLUORESCENT
DISPLAY
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Remove instrument cluster from vehicle. Refer
to Electrical, Instrument Cluster, Removal.
(3) Remove six cluster back cover retaining screws
and remove the cover.
(4) Carefully unplug the connector from printed
circuit board.
(5) Remove six attachment screws and then
remove cluster mask/lens from the instrument clus-
ter.
(6) Carefully pull the dial assembly from the hous-
ing to separate connection with the PC-board.
(7) Remove two screws from the back of the dial
assembly to remove the VF-display.
INSTRUMENT CLUSTER
(8) Remove the VF-display from the cluster.
INSTALLATION
(1) Position the VF-display onto the dial assembly
and install the two screws.
(2) Carefully push the dial assembly into the hous-
ing to make the connection with the PC-board.
(3) Install the six attachment screws and then
install cluster mask/lens to the instrument cluster.
(4) Carefully plug the connector into the printed
circuit board.
(5) Install the cover and the six cluster back cover
retaining screws.
(6) Install the instrument cluster into vehicle.
Refer to Electrical, Instrument Cluster, Installation.
(7) Connect the negative battery cable remote ter-
minal to the remote battery post.
8J - 3
Advertisement
Table of Contents
