Table of Contents
Advertisement
JR
POWER MIRRORS
DESCRIPTION
. . . . . . . . . . . . . . . . . . . . . . . . . . 7
OPERATION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
DIAGNOSIS AND TESTING - POWER
MIRRORS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
AUTOMATIC DAY / NIGHT MIRROR
DESCRIPTION
. . . . . . . . . . . . . . . . . . . . . . . . . . 8
OPERATION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
DIAGNOSIS AND TESTING - AUTOMATIC
DAY/NIGHT INSIDE MIRROR
POWER MIRRORS
DESCRIPTION
AUTOMATIC DAY/NIGHT MIRROR
The automatic day/night mirror system is able to
automatically change the reflectance of the inside
rear view mirror in order to reduce the glare of head-
lamps approaching the vehicle from the rear. The
automatic day/night rear view mirror receives bat-
tery current through a fuse in the junction block only
when the ignition switch is in the ON position.
OUTSIDE REAR VIEW MIRROR
The power operated outside rear view mirrors
allow the driver to adjust both outside mirrors elec-
trically from the driver side front seat position by
operating a switch on the instrument panel to the
left of the steering column.
OPERATION
AUTOMATIC DAY/NIGHT MIRROR
A switch located on the bottom of the automatic
day/night mirror housing allows the vehicle operator
to select whether the automatic dimming feature is
operational. When the automatic day/night mirror is
turned on, the mirror switch is lighted by an integral
Light-Emitting Diode (LED). The mirror will auto-
matically disable its self-dimming feature whenever
the vehicle is being driven in reverse.
Refer to the owner's manual for more information
on the features, use and operation of the automatic
day/night mirror system.
POWER MIRRORS
TABLE OF CONTENTS
page
. . . . . . . . . . . . . . 8
POWER MIRROR SWITCH
DIAGNOSIS AND TESTING - POWER MIRROR
SWITCH
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
REMOVAL
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
INSTALLATION
. . . . . . . . . . . . . . . . . . . . . . . . . . 9
SIDEVIEW MIRROR
REMOVAL
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
OUTSIDE REAR VIEW MIRROR
The power mirrors receive a non-switched battery
feed through a fuse in the junction block so that the
system will remain operational, regardless of the
ignition switch position.
DIAGNOSIS AND TESTING - POWER MIRRORS
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the power mirror switch. (Refer to 8 -
ELECTRICAL/POWER MIRRORS/POWER MIRROR
SWITCH - REMOVAL).
(3) Disconnect wire connector from the switch.
(4) Using two jumper wires, one connected to a 12
volt battery source, and the other connected to a good
body ground. Refer to the Mirror Motor Test table for
appropriate mirror response, using the mirror switch
wiring harness connector (Fig. 1).
(5) If test results are not obtained as shown in the
Mirror Motor Test table, check for open or shorted
circuit, or replace mirror assembly as necessary.
If mirror motor tests OK, go to Mirror Switch Test.
MIRROR MOTOR TEST
12 VOLT
GROUND
9
10
4
1
10
9
1
4
10
2
1
8
2
10
8
1
POWER MIRRORS
MIRROR REACTION
LEFT
RIGHT
UP
DOWN
DOWN
RIGHT
RIGHT
LEFT
LEFT
8N - 7
page
UP
Advertisement
Table of Contents
