Table of Contents
Advertisement
JR
ROTOR (Continued)
Fig. 55 Checking Rotor For Thickness
1 - MICROMETER
Fig. 56 Checking Rotor Runout
1 - SPECIAL TOOL SP-1910
2 - 25 mm FROM EDGE
3 - DISC SURFACE
4 - SPECIAL TOOL C-3339
If runout is in excess of the specification, check the
lateral runout of the hub face. Before removing the
rotor from the hub, place a chalk mark across both
the rotor and the one wheel stud closest to where the
high runout measurement was taken. This way, the
original mounting spot of the rotor on the hub is
indexed (Fig. 57).
Fig. 57 Marking Rotor and Wheel Stud
1 - CHALK MARK
Remove the rotor from the hub.
NOTE: Clean the hub face surface before checking
runout. This provides a clean surface to get an
accurate indicator reading.
BRAKES - BASE
5 - 33
Advertisement
Table of Contents
