Installation; License Plate Lamp Removal; License Plate Lamp Unit Removal - Chrysler 300M 2002 Service Manual

8L - 26 LAMPS/LIGHTING - EXTERIOR
HEADLAMP UNIT (Continued)

INSTALLATION

CONCORDE/300M
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
NOTE: If replacing complete headlamp unit, transfer
halogen bulb to new unit.
(1) Put headlamp under crossmember to install it
into the vehicle.
(2) Install the electrical connectors to the head-
lamp, and lower the crossmember on the side being
serviced.
(3) Install the upper crossmember attachments,
both sides, headlamp jackscrews, windshield filler
neck screw, and speed control servo screw.
(4) Install the headlamp sight shield (300M).
(5) Connect and the battery negative cable.
(6) Verify headlamp operation and alignment.
(7) Close hood.
INTREPID
NOTE: Headlamp lens fogging is a normal condition
and does not require service unless excessive or
continual. Moisture will vent from tubes or vents
located on the back of the lamp.
(1) Place headlamp housing in position on vehicle.
(2) Connect wire connectors to headlamp, parking,
side marker, and turn signal lamps.
(3) Place headlamp in position on body.
(4) Install screws to attach headlamp to body.
(5) Connect the battery negative cable and close
hood.
(6) Verify headlamp operation and alignment.
LICENSE PLATE LAMP
REMOVAL
(1) Remove screws attaching license plate lamp to
rear bumper fascia.
(2) Remove license plate lamp from rear bumper
fascia.
(3) Remove socket from lamp (Fig. 33).
(4) Pull bulb from socket.
INSTALLATION
(1) Push bulb into socket.
(2) Install socket into lamp.
(3) Place license plate lamp in position on rear
bumper fascia.
Fig. 33 LICENSE PLATE LAMP
1 - LICENSE PLATE LAMP
2 - TRUNK LID
3 - SOCKET
4 - BULB
(4) Install screws to attach license plate lamp to
rear bumper fascia.
LICENSE PLATE LAMP UNIT
REMOVAL
(1) Remove screws holding license plate lamp to
fascia (Fig. 34).
(2) Remove license plate lamp from vehicle.
Fig. 34 LICENSE PLATE LAMP UNIT
1 - APPLIQUE OR FASCIA
2 - LICENSE PLATE LAMP
LH