Suzuki Wagon R Manual page 2776

1 2
When Replacing Compressor
CAUTION:
Be sure to use P/N: 99000-990C5-00A compressor oil or
an equivalent compressor oil.
Compressor oil is sealed in each new compressor by the amount
required for A/C system. Therefore, when using a new compres-
sor for replacement, drain oil from it by the amount calculated as
follows.
"C" = "A" – "B"
"C": Amount of oil to be drained
"A": Amount of oil sealed in a new compressor
"B": Amount of oil remaining in removed compressor
NOTE:
Compressor assembly supplied from factory is filled up
with the following amount of oil.
Oil amount in compressor
3
100 cm (100 cc, 6.1 in
1. New compressor
2. Removed compressor
M13 and G10 Engine Models
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
Magnet Clutch
Inspection
Z13DT Engine Model
• Check armature plate and magnet clutch pulley for wear and
oil soaked conditions respectively.
• Check magnet clutch pulley bearing for noise, wear and
grease leakage.
•
Measure magnet clutch coil for resistance at 20
If the measured resistance does not remain within above tol-
erance, replace compressor assembly.
Standard Resistance: approximately 3.7
AIR CONDITIONING (OPTIONAL) 1B-25
3
)
°
Ω
°
C (68 F).