Storage, Assembly And Transport; Mechanical Setup; Installation Position; Total Expansion - WAGO I/O System 750 Series Manual

18 •
The WAGO-I/O-SYSTEM 750

Storage, Assembly and Transport

2.5 Storage, Assembly and Transport
Wherever possible, the components are to be stored in their original packag-
ing. Likewise, the original packaging provides optimal protection during
transport.
When assembling or repacking the components, the contacts must not be
soiled or damaged. The components must be stored and transported in appro-
priate containers/packaging. Thereby, the ESD information is to be regarded.
Statically shielded transport bags with metal coatings are to be used for the
transport of open components for which soiling with amine, amide and sili-
cone has been ruled out, e.g. 3M 1900E.

2.6 Mechanical Setup

2.6.1 Installation Position

Along with horizontal and vertical installation, all other installation positions
are allowed.
Attention
In the case of vertical assembly, an end stop has to be mounted as an addi-
tional safeguard against slipping.
WAGO item 249-116
WAGO item 249-117

2.6.2 Total Expansion

The maximum total expansion of a node is calculated as follows:
Quantity
1
64
1
sum
Warning
The maximal total expansion of a node must not exceed 830 mm
End stop for DIN 35 rail, 6 mm wide
End stop for DIN 35 rail, 10 mm wide
Width Components
50 mm ECO coupler
12 mm bus modules
- inputs / outputs
- power supply modules
- etc.
12 mm end module
830 mm
WAGO-I/O-SYSTEM 750
DeviceNet