How To Login Via The Eth1 Port; How To Change Your Security Settings - Eurotech DynaGate 10-12 Series User Manual

12 How to log in the Administration Console
1. Enter the command ssh root@172.16.0.1
2. At the prompt, enter the password (see
12.3.2

How to login via the eth1 port

DynaGATE 10-12 eth1 port is configured in DHCP client mode.
You have to know its IP address before you can log in, or you have to use a zeroconf implementation.
NOTICE
By default the DynaGATE 10-12 runs a zeroconf implementation.
You can detect the IP address of the unit remotely by running the command: avahi-discover.
Example:
1. Run the command: avahi-discover. A dialog box pops-up reporting all the devices on
your network that support this mechanism
2. Under "eth0 IPv4" > "local" > "Workstation", you should see your product's hostname
(example: productname_serialnumber). Select it to see its IP address
3. Log in your Reliagate using: ssh root@productname_serialnumber.local
4. At the prompt, enter the password: (see
12.4

How to change your security settings

For security reasons, Eurotech recommends you to change the Linux 'root' password after your initial
setup.
To change your Linux password, complete the following steps:
1. Login using the console port
2. Run the passwd command and enter a new 'root' account password
80 / 94
"The default credentials" on the previous
"The default credentials" on the previous
DynaGATE 10-12 User manual Rev. 0-14
page).
page).