How To Login Via Eth0; How To Login Via Eth1; How To Change The Password - Eurotech ReliaGATE 10-12-6 Series User Manual

11 How to login the Administration Console
11.3.1

How to Login Via eth0

To login using eth0, complete the following steps:
1. Enter the command ssh root@172.16.0.1
2. At the prompt, enter the password (see
11.3.2

How to Login via eth1

To login using eth1, you need to know its IP address. Use a zeroconf implementation to detect it.
By default, the ReliaGATE 10-12 runs a zeroconf implementation.
You can detect remotely the IP address of the ReliaGATE 10-12 by running the command: avahi-
discover.
Example:
1. Run the command: avahi-discover. A dialog box pops-up reporting all the devices on your
network that support this mechanism
2. In "eth1 IPv4" > "local" > "Workstation", you should see your product's hostname (example:
productname_serialnumber). Select it to see its IP address
3. Login the ReliaGATE 10-12 using: ssh root@productname_serialnumber.local
4. At the prompt, enter the default password (see
11.4

How to change the password

For security reasons, Eurotech recommends you to change the password of the "root" account after your
initial setup.
To change the password, complete the following steps:
1. Login the Administration Console
2. Run the command passwd. You will be prompted to enter your old password for verification, and
then a new password.
70 / 118
"Default credentials" on the previous
"Default credentials" on the previous
ReliaGATE 10-12 User manual Rev. 2-1
page).
page).