Table of Contents
Advertisement
DynaGATE 10-12 User manual Rev. 0-14
9
H
OW TO SUPPLY POWER TO THE PRODUCT
NOTICE
This product is not provided with any ON/OFF switch.
The Power IN connector is the disconnecting means from the power supply network.
9.1
Power supply specifications
Power supply
Power consumption
Peak demand
9.1.1
Power IN connector and mating connector specifications
The power input is protected against: surge, noise, reverse polarity, over-voltage.
NOTICE
The Power IN connector is NOT protected against short circuit.
Always include an external fuse to protect the product!
The DynaGATE 10-12 provides the Power IN connector on the rear panel.
Connector Layout:
1
Connector Specifications:
Base strip, Header
l
Gender: Male
l
Type: 3-pin, 3.5 mm pitch
l
Mating Connector Specifications:
Pluggable screw terminal block
l
Gender: Female
l
Type: 3-pin, 3.5 mm pitch
l
Example:
l
Manufacturer: Phoenix Contact
Part Number: MC 1,5/ 3-STF-3,5 - 1847068
(or equivalent)
Nominal: 12 or 24 VDC; Range: 9 to 36 VDC with transient protection and Vehicle Ignition Sense
2 W typical; 15 W maximum
< 15 W
3
9 How to supply power to the product
Connector Pinout:
Pin #
Signal
Type Description
1
Power IN +
2
Power IN -
3
KEY
P
Positive power supply input
P
Negative power supply input
P
Vehicle Ignition Sense
57 / 94
Advertisement
Table of Contents
