Preventing Electrostatic Discharge; Safely Connecting Power To The Product; Wireless Safety Information; Caution: Product's Surfaces May Become Hot - Eurotech DynaGate 10-12 Series User Manual

DynaGATE 10-12 User manual Rev. 0-14
1.3

Preventing electrostatic discharge

NOTICE
1.4

Safely connecting power to the product

To safely connect power to the product:
Observe all the instructions for safety, installation, and operation
l
Never operate with wet hands
l
Use certified power cables
l
Make sure the power cables are not damaged before using them
l
Make sure that the power cables meet the power requirements of the devices
l
Position cables with care. Do not position cables in places where they may be trampled or
l
compressed by objects placed on them
Make sure that the power-points and plugs are not damaged before using them
l
Do not overload the power-points and plugs
l
Use a power supply that meets the requirements stated on the identification label of the
l
product. In case of uncertainties about the required power supply, contact the Eurotech
Technical Support Team (for more information see
page 11).
1.5

Wireless safety information

The antennas used in the product have to be installed with care in order to avoid any interference with other
electronic devices and to guarantee a minimum distance from the body (20 cm).
In case of this requirement cannot be satisfied, the system integrator has to assess the final product
against the SAR regulations.
1.6

Caution: Product's surfaces may become hot

Depending on the operating environment temperature, product's surfaces may become hot, creating a burn
hazard.
Always allow the product's surfaces to cool before touching them.
HOW TO PREVENT DAMAGING ELECTROSTATIC-SENSITIVE DEVICES
The symbol on the left is applied on electrostatic-sensitive devices.
To prevent damaging electrostatic-sensitive devices:
Handle the electrostatic-sensitive devices in an ESD Protected Area (EPA)
l
Observe the appropriate antistatic precautions. For example: use a wrist
l
strap kept in constant contact with bare skin and attached to ground.
"Receiving technical assistance" on
1 Safety instructions
9 / 94