NEC Univerge SV8100 VM8000 InMail System Manual page 99

VM8000
3.
4.
5.
Unscreened Transfer
Screened Transfer
InMail System Guide
Set up Directory Lists to control which extensions Directory Dialing can access.
47-02-15 Directory List (Directory List)
Select the Directory List to which the extension belongs. The entries are
1~8 (for lists 1~8), 0 (for no list), or * (for all lists). Directory Dialing to the
extension can occur only if the list entry matches the setting in 47-15-02
Directory List Number to Use for the Directory Dialing Mailbox.
By default, extensions are not included in a Directory List (0).

47-15-02 Directory List Number to Use (Directory List)
The Directory Dialing Mailbox can route calls only to the members of the
Directory List specified in this option. The entries are 1~8 (for lists 1~8).
By default, the Directory Dialing Mailbox uses list 1.

Specify the required number of letters of the employee name the caller must
dial.
47-15-01 Minimum Number of Letters Required (Min Num Letters)
Specify how many letters of an employee's name the caller must dial to use
Directory Dialing. If the caller dials less than the specified minimum number
of letters, VM8000 InMail cannot route the call. The entries are 1~3 (1~3
letters).
By default, callers must dial at least 1 letter of the employee's name (1).

Select Screened or Unscreened Transfer call routing, when Directory Dialing
finds a name match.
47-15-04 Unscreened or Screened Transfer (Transfer Option)
Enter 1 to route the call as an Unscreened Transfer.
By default, VM8000 InMail routes the call as a Screened Transfer (0).

47-15-04 Unscreened or Screened Transfer (Transfer Option)
Enter 0 to route the call as a Screened Transfer.
By default, VM8000 InMail routes the call as a Screened Transfer (0).

47-15-05 Screened Transfer Timeout (Scrn Trf Timeout)
Set how long a Screened Transfer from the Directory Dialing Mailbox will
ring an unanswered extension before recalling. The entries are 1~255
seconds or 0 for no recall.
By default, the Screened Transfer Timeout interval is 15 seconds.

Issue 1.0
2 - 71