NEC Univerge SV8100 VM8000 InMail System Manual page 292

Issue 1.0
3 - 6
Keys for Entering Names
When entering names in the procedures below, refer to this chart. Names can be up to
12 digits long.
Use this keypad
digit . . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0
Enter characters:
¢ £
# # = Accepts an entry (only required if two letters on the same key
are needed - ex: TOM). Pressing # again = Space. (In system
programming mode, use the right arrow soft key instead to accept
and/or add a space.)
Conf Clear the character entry one character at a time.
Hold Clear all the entries from the point of the flashing cursor and to the
right.
Options
Characters (12 maximum, using upper and lower case letters).
Use a space or comma as the delimiter between the first and last name.
Default
No extension names entered.
Key for Entering Names
When you want to. . .
! " # $ % &
+ , - . / : ;
→ ←
Á À Â Ã Ç É Ê ì ó
) ô Õ ú ä ö ü α ε θ
' (
< = > ?
B E
Programming
VM8000
σ ∞
S