NEC Univerge SV8100 VM8000 InMail System Manual page 360

Issue 1.0
Hang Up Action (6) (HNGUP)
When an Automated Attendant caller presses a key assigned to this action, VM8000
InMail says "Goodbye" and immediately hangs up.
GOTO Action - Go to Mailbox (7) (GOTO)
Use this option to provide Automated Attendant callers with the ability to route to Call
Routing and Announcement Mailboxes. For example, a caller can dial a digit for
Sales, and then go to the Call Routing or Announcement Mailbox that provides the
dialing options and instructions for Sales.
3 - 74
To log on to any valid Subscriber Mailbox, enter IXXX in the corresponding
Number option.
For example, to allow callers to dial 1 plus any Subscriber Mailbox number to log

on, for key 1 enter LOGON for the Action and IXXX for the corresponding
Number.
Additional Information
See Log On to Voice Mail on page 2-141
Number Option
No entry is required in the corresponding Number option.
Additional Information
See Hang Up on page 2-127

Number Option
To have Automated Attendant callers dial a single digit to go to a Call
Routing or Announcement Mailbox, enter the mailbox number in the
corresponding Number option.
For example, to have key 1 go to Call Routing Mailbox 1, for key 1 enter GOTO for

the Action and 1 for the corresponding Number.
To have VM8000 InMail require Automated Attendant callers to enter a Call
Routing or Announcement Mailbox to go to, enter XXX in the corresponding
Number option. The key you choose must represent the first digit in the
mailbox numbers.
For example, to allow callers to go to mailboxes 1~16, for key 0 enter GOTO for

the Action and XXX for the corresponding Number.
To log into any valid Call Routing or Subscriber Mailbox, enter IXXX in the
corresponding Number option.
For example, to allow callers to dial 1 plus any Call Routing or Announcement

Mailbox number to go to, for key 1 enter GOTO for the Action and IXXX for the
corresponding Number.
Additional Information
See Go To A Mailbox on page 2-107
for more information.
for more.
for more information.
VM8000
Programming