NEC Univerge SV8100 VM8000 InMail System Manual page 341

VM8000
InMail System Guide
Options
0 (Undefined)
1 (Station Mailbox)
2 (Group Mailbox)
3 (Routing Mailbox)
Default
0 (Undefined)
I f any of the Input Data values are entered, the terminal displays the Override Mailbox

Number selection (below).
47-11-02 Override Mailbox Number (Override MB Num)
Use this option to specify the mailbox to which Automated Attendant calls
should route when you when you enable Answer Schedule Override. The
mailbox number you select in this option should match the mailbox category
specified in 47-11-02 Override Mailbox Category above.
Options
Digits (3 maximum, using 0-9).
Default
No entry.
47-11-03 Default Mailbox Category (Default MB Ctg)
Use this option to specify the category of mailbox used as the Default
Mailbox. VM8000 InMail mailbox categories are Subscriber Mailbox, Group
Mailbox, and Routing Mailbox. VM8000 InMail uses the Default Mailbox
whenever an Answer Schedule is not in effect.
VM8000 InMail handles the routing according to the type of mailbox
(Subscriber, Call Routing, or Announcement) within the specified category:
If the Default Mailbox is a Subscriber Mailbox, the outside caller hears the
H
mailbox greeting (if recorded) and can leave a message.
If the Default Mailbox is an Announcement Mailbox, the outside caller hears
H
the recorded announcement. Depending on how the Announcement
Mailbox is programmed, VM8000 InMail then hangs up, reroutes the call, or
provides additional dialing options.
If the Default Mailbox is a Call Routing Mailbox, the outside caller hears the
H
instruction menu and can dial any option allowed by the associated Dial
Action Table.
If the Default Mailbox is a Directory Dialing Mailbox, the outside caller can
H
reach an extension by dialing the first few letters in the extension user's
name
See

Options
0 (Undefined)
1 (Station Mailbox)
2 (Group Mailbox)
3 (Routing Mailbox)
Answer Tables on page 2-29.
Issue 1.0
3 - 55