System Re-Initialization - NEC Univerge SV8100 VM8000 InMail System Manual

VM8000
Description
Initializing the telephone system automatically initializes all VM8000 InMail
programming. You may want to do this if the site requirements significantly change
and it is easier to start over from default than remove all your custom programming.
Re-initializing VM8000 InMail returns all programmed options to their default values.
Re-initializing the telephone system returns all programmed options to their factory
To initialize (erase) Subscriber Mailbox Security Codes and all recordings, use a
System Administrator Mailbox.
Related Features
System Administrator
Programming
To initialize (Cold Start) the telephone system:
1.
2.
3.
4.
5.
6.
InMail System Guide
set (default) values. Any site specific programming you have done is erased
The System Administrator can delete Subscriber Mailbox security codes as well as
VM8000 InMail recorded messages.
Make sure the system (not VM8000 InMail) CompactFlash card is not installed.
The system does not boot correctly if the system CompactFlash card is installed.

Push the power button to Off.
Wait 10 seconds before going to the next step.
This gives the system time to complete the shutdown process.

Press and hold the Load button, then turn the power switch to On.
Continue to hold down the Load button for at least 3 seconds.
Release the Load button.
The system restarts in about 2 minutes.

When the system restarts, the Live LED flashes red.


System Re-initialization

following re-initialization.
Issue 1.0
2 - 235