Fuel Injection Pump Timing - Check - Perkins 1103 Series Workshop Manual

24
Testing and Adjusting Section
Note: The camshaft gear can rotate a small amount
when the pin is installed.
5. Remove the timing pins from the camshaft gear
and the crankshaft web.
Fuel Injection Pump Timing -
Check
Delphi DP210 Series Fuel Injection
Pump
Note: The Delphi DP210 Series fuel injection pump
timing cannot be checked. If you suspect that the
fuel injection pump timing is incorrect, contact your
Perkins dealer or your Perkins distributor for further
information.
The Delphi DP210 Series fuel injection pump must
be serviced by an authorized Delphi technician. For
repair information, contact your Perkins dealer or
your Perkins distributor. The internal adjustment for
the pump timing is tamper proof. High idle and low
idle are factory set. Idle adjustments can not be
made to the fuel pump.
Bosch EPVE Fuel Injection Pump
Note: The Bosch EPVE fuel injection pump is only
installed on the 1104 engine.
Table 2
Required Tools
Part
Part Description
Number
Bosch EPVE fuel injection pump
27610248
timing adapter
1. Set the number one piston at the top center
piston on the compression stroke. Refer to
Testing and Adjusting,
Position for the No. 1 Pistion
2. Remove the high pressure fuel lines from the fuel
injection pump.
i01900283
Qty
1
" Finding Top Center
" for the procedure.
Illustration 18
(1) Plug
Illustration 19
(2) Bosch EPVE fuel injection pump timing adapter
(3) Dial indicator
3. Remove the plug (1) and the washer from
the rear of the fuel injection pump and install
27610248 fuel injection pump timing adapter (2).
Install a suitable dial indicator (3) into
fuel injection pump timing adapter. Set the dial
indicator to approximately 3 mm (0.1181 inch).
4. Rotate the crankshaft counterclockwise until the
dial indicator (3) indicates that the plunger of the
fuel injection pump is at the bottom of the stroke.
Set the dial indicator (3) to zero.
g00988405
g00988406
27610248