Camshaft Gear - Remove And Install - Perkins 1106C Series Disassembly And Assembly

130
Disassembly and Assembly Section
1. Clean the camshaft and the thrust washer.
Inspect the camshaft and the thrust washer for
wear and for damage. Refer to Specifications,
"Camshaft" for more information. Replace any
worn components or any damaged components.
2. Clean the camshaft bearing in the cylinder
block. Inspect the camshaft bearing for wear
and for damage. Refer to Specifications,
"Camshaft Bearings" for more information. If
necessary, replace the camshaft bearing. Refer to
Disassembly and Assembly, "Camshaft Bearing
- Remove and Install".
NOTICE
It is strongly recommended that all lifters should be
replaced when a new camshaft is installed.
3. Inspect the lifters for wear and for damage.
Refer to Specifications, "Lifter Group" for more
information. Replace any worn lifters or any
damaged lifters. Refer to Disassembly and
Assembly, "Lifter Group - Remove and install".
Illustration 262
Typical example
4. If necessary, install a new key (4) into camshaft
(3).
5. Lubricate the bearing surfaces of camshaft (3)
and lubricate the lobes of the camshaft with clean
engine oil.
NOTICE
Do not damage the lobes or the bearings when the
camshaft is removed or installed.
6. Carefully install camshaft (3) into the cylinder
block.
Illustration 263
Typical example
7. Lubricate the thrust washer with clean engine oil.
Align slot (X) in thrust washer (1) with dowel (2) in
the cylinder block. Install thrust washer (1) into the
recess in the cylinder block.
Note: The thrust washer can have one or two slots
(X).
End By:
a. Install the front housing. Refer to Disassembly and
Assembly, "Housing (Front) - Install".
b. Install the rockershaft and pushrods. Refer to
Disassembly and Assembly, "Rocker shaft and
Pushrod - Install".
Camshaft Gear - Remove and
Install
g01340531
Removal Procedure
Table 58
Tool Part Number
A
A
B
C
Required Tools
Part Name
Crankshaft Turning
21825576
Tool
Crankshaft Turning
27610289
Tool
27610290
Gear
27610212
Camshaft Timing Pin
27610286
Crankshaft Timing Pin
27610287
Adapter
KENR6932
g01167327
i02654457
Qty
1
1
1
1
1
1