700 Series
3
Cylinder head assembly
Rocker cover
To remove and to fit
Special requirements
Torque Nm (lbf ft) kgf m
Cap nuts
Cautions:
l If the cap nut is over-tightened, the stud and plate assembly for the rocker pedestal may be damaged.
l When the crossover pipe is removed, cover the holes in the turbocharger and in the induction manifold to
prevent the entry of dirt.
Note: On UC engines, the crossover pipe (A1) must be removed first.
UC ENGINES
ONLY
Workshop Manual, TPD 1392E, issue 3
This document has been printed from SPI². Not for Resale
11 (8) 1,1
1
3
Operation 3-1
35