One Blower Operation; Auxiliary Control Panel; Power On / Off - Arjohuntleigh KinAir MedSurg Pulse User Manual

One Blower Operation

Use One Blower operation while performing maintenance procedures or under other special circumstances, such as when
softer mattress pressures are required.
Press ONE BLOWER button to turn blower ON / OFF.
NOTE: LED displays One Blower operation status and toggles ON and OFF.
NOTE: With each subsequent illumination of the LED on the ONE BLOWER
button, the Blower affected will alternate. If Blower A is active, the next
cycle of the LED will indicate Blower B's status as ON.
3. Press Arm button to activate Bed Exit Alarm function.
4. Press Disarm button to deactivate Bed Exit Alarm function.

AUXILIARY CONTROL PANEL

The Auxiliary Control Panel is located at the footend of the unit immediately below the Foot Board.
Use the Auxiliary Control Panel to:
•
Power the unit ON / OFF
•
Silence Alarms as they occur
•
Activate or deactivate Seat Deflate feature.

Power ON / OFF

POWER ON
•
Press the POWER ON / OFF button to turn air supply to the unit on. LED will light.
NOTE: As the blowers start, the AIR ADJUST LED's will climb to near maximum levels, then settle to normal.
POWER OFF
•
Press the POWER ON button to turn air supply to the unit off. LED will dim; air cushions will deflate.
5-7
ONE
BLOWER