Lockouts - Arjohuntleigh KinAir MedSurg Pulse User Manual

•
Press the FOOT LOCKOUT button located on the Bed Motion Control Panel to lock out the
knee gatch.
•
Press the BED UP arrow or press the BED DOWN lever located on the Bed Motion Control
Panel to raise patient surface to its full height.
•
Pull out the REVERSE TRENDELENBURG lever located on the Bed Motion Control
Panel, as shown at right.
•
Press the BED DOWN arrow to adjust patient support surface from 0° to 8° Reverse
Trendelenburg.
NOTE: Angle of Trendelenburg and Reverse Trendelenburg are displayed on the
Trendelenburg Gauges located on both the left and right sides of the unit's
frame supports, as shown at right.

Lockouts

Use Lockouts to selectively disable bed angle and height adjustments.
NOTE: To Lockout Air Adjustments, see the Air Adjustment Lockout section in this chapter.
HEAD LOCKOUT
Use Head Up / Down Lockout to prevent intentional or unintentional changes to the Head Angle.
To perform lockout:
1. Press the HEAD Lockout button located on the Bed Motion Control Panel.
NOTE: When lockout is engaged, button will remain pressed down.
2. Observe that Head Up / Down controls are disabled.
To disable lockout:
1. Press the HEAD Lockout button on the Bed Motion Control Panel.
NOTE: When lockout is disabled, button will release.
2. Observe that Head Up / Down controls are functioning.
5-13
T R E N D E L E N B U R G
INCHES
6 3 0
15 12 9 9 9