Bleeding The Hood Cylinder - Wexiodisk WD-90 DUO Installation And User Manual

Installation

3.6.2 Bleeding the hood cylinder

Bleeding of the lifting cylinder for the hood should be performed when the dish-
washer is filling with water on start-up. Proceed as follows:
1. Loosen the plug in the bleed valve at the very top of the hood.
2. Start the dishwasher by pressing the button for switch-on/switch-off.
3. If hood opening does not start, press the button for operating the hood (up
and down).
4. Wait until water comes up through the hole in the bleed valve.
5. Tighten the plug by hand.
6. Open and close the hood using the button for operating the hood (at the
very bottom of the panel).
7. Loosen the plug in the bleed valve and check that there is no more air
coming out of the valve.
Bleed valve for hood lifting cylinder
WD-90 DUO
15
Rev. 0 (201401)
25-4-05-002_1