Updating Firmware - Ricoh MPC 2800 AT-C2 Field Service Manual

Updating Firmware

Preparation
• If the SD card is blank, copy the entire "romdata" folder onto the SD card.
• If the card already contains the "romdata" folder, copy the "D023" folder onto the card.
If the card already contains folders up to "D023", copy the necessary firmware files (e.g. D023xxxx.fwu)
into this folder.
• Do not put multiple machine firmware programs on the same SD card. Copy the only model firmware
you want.
Updating Procedure
1. Turn the main power switch off.
2. Remove the slot cover ( x 1).
3. Insert the SD card into SD Card Slot 2. Make sure the label on the SD card faces the front side of the
machine.
4. Slowly push the SD card into the slot so it locks in place. You will hear it click. Make sure the SD card
locks in place.
• To remove the SD, push it in to unlock the spring lock. Then release it so it pops out of the slot.
5. Disconnect the network cable from the copier if the machine is connected to a network.
6. Switch the main power switch on. After about 45 seconds, the initial version update screen appears
on the LCD in English.
7. On the screen, touch the button or press the corresponding number key on the operation panel to
select the item in the menu that you want to update.
ROM/NEW
ROM:
NEW:
Tells you the number of the module and name of the version currently installed.
The first line is the module number, the second line the version name.
Tells you the number of the module and name version on the SD card. The first
line is the module number, the second line the version name.
What it means
Firmware Update
5
309