Ricoh MPC 2800 AT-C2 Field Service Manual page 320

5. System Maintenance Reference
Error occurred when ROM update
23
program started
24 SD card access error
No HDD available for stamp data
30
download
Data incorrect for continuous
31
download
Data incorrect after download
32
interrupted
33 Incorrect SD card version
5
Module mismatch - Correct
34
module is not on the SD card)
Module mismatch – Module on
35
SD card is not for this machine
Cannot write module – Cause
36
other than E34, E35
40 Engine module download failed
Operation panel module
42
download failed
Stamp data module download
43
failed
Controller module download
44
failed
Electronic confirmation check
50
failed
318
Controller program abnormal. If the second attempt fails,
replace controller board.
Make sure SD card inserted correctly, or use another SD
card.
HDD connection incorrect or replace hard disks.
Insert the SD card with the remaining data required for
the download, the re-start the procedure.
Execute the recovery procedure for the intended module
download, then repeat the installation procedure.
Incorrect ROM data on the SD card, or data is corrupted.
SD update data is incorrect. Acquire the correct data
(Japan, Overseas, OEM, etc.) then install again.
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.
Replace the update data for the module on the SD card
and try again, or replace the BICU board.
Replace the update data for the module on the SD card
and try again, or replace the LCDC.
Replace the update data for the module on the SD card
and try again, or replace the hard disks.
Replace the update data for the module on the SD card
and tray again, or replace controller board.
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.