Ricoh MPC 2800 AT-C2 Field Service Manual page 140

2. Installation
• [a]: "ROM Number/Firmware Version" – "HDD Format Option"
• [b]: "Loading Program" – "GW5a_zoffym"
Diagnostic Report:
2
Data Overwrite Security Unit
• The ROM number and firmware version number change when the firmware is upgraded.
However, the important thing is to make sure the numbers in [a] are the same as the numbers in
[b].
• If the ROM numbers are not the same, or the version numbers are not the same, this means the
unit was not installed correctly.
If this happens:
Make sure of the unit type (must be Type H).
12. Go into the User Tools mode, and select System Settings> Administrator Tools> Auto Erase Memory
Setting> On.
13. Exit the User Tools mode.
14. Check the display and make sure that the overwrite erase icon [1] shows.
15. Check the overwrite erase icon.
• The icon [2]: This icon is lit when there is temporary data to be overwritten, and blinks during
overwriting.
• The icon [3]: This icon is lit when there is no temporary data to be overwritten.
138
"ROM No. / Firmware
Version" [a]
HDD Format Option:
D3775912 / 1.00m
"Loading Program" [b]
GW5a_zoffym:
D3775912 / 1.00m