Ricoh MPC 2800 AT-C2 Field Service Manual page 607

001 Number: Bk
002 Number: M
003 Number: C
004 Number: Y
005-00
Sets the execution flag for the toner supply mode for each color.
8
005 Execution Flag: Bk
006 Execution Flag: M
007 Execution Flag: C
008 Execution Flag: Y
3041 [Process Control Type]
Voltage Control
001
Enables or disables potential control.
LD Power Control
002
Selects the LD power control mode.
Pre-ACC
004
Selects the process control mode that is done before ACC.
*ENG [0 to 30 / 8 / 1 sec/step]
*ENG
*ENG [0 to 30 / 6 / 1 sec/step]
*ENG
*ENG
[0 or 1 / 0 / 1/step]
*ENG
0: Flag OFF, 1: Flag ON
This flag is cleared after executing TD sensor
*ENG
initialization.
*ENG
[0 or 1 / 1 / 1/step ] Alphanumeric
0: FIXED (Use the fixed values for the charge DC
*ENG bias and development DC bias set with SP2-005
and SP2-229.)
1: CONTROL
[0 or 1 / 1 / 1/step] Alphanumeric
*ENG 0: FIXED (at the value in SP2221-xxx)
1: CONTROL (adjusted by process control)
[0 to 2 / 2 / 1/step]
0: Not Executed
*ENG 1: Process Control
2: TC Control (TD Adjustment)
3: Not used
System Service Mode
8
251