Removing The Grate-Shaped Lower Guide; Removing The Stapler - Canon Saddle Finisher-T2 Service Manual

tray cable. To prevent the gear phase from shifting
due to the front and rear rails, the tray must be
attached horizontally. Lower the tray [1] to the
position shown in the figure and compare the
heights of the shutter guide top edges [2] with those
of the tray projections [3] at the front and rear to
check that the tray is attached horizontally. If their
heights are not the same, remove the tray and then
attach it again.
[2]
[1]
F-3-306
3.4.2.8 Removing the Grate-
shaped Lower Guide
1) Remove ten screws [1] and remove the grate-
shaped lower guide [2].
When replacing, be careful not to hook the grate-
shaped lower guide to the sensor flag arm on the
delivery side.

3.4.2.9 Removing the Stapler

1) Pull out the stapler, remove screw [1], and remove
the PCB cover [2].
[3]
0009-3706
2) Release the claw [1] and remove the PCB [2].
3) Disconnect three connectors [3].
4) Remove screw [4] and remove the stapler together
with the stapler base [5].
[1]
[2]
F-3-307
F-3-308
When removing, be careful not to damage the flag
[6].
Chapter 3
[1]
[1]
0009-3707
[2]
[1]
3-75