Canon Saddle Finisher-T2 Service Manual page 232

Chapter 4
No.
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
3. Necessary Tool
The following item needs to be prepared for download.
Computer (PC)
Prerequisite: The download tool (Ver. 3.11E or higher) must be downloaded to the PC.
4. Download Procedures
a. Registering ROM data
4-46
[5] [8]
Description Function
START/STOP key A key to be pressed when you start or stop download
LOAD LED To be lit when download is available.
Model LED To be lit when the Finisher is connected.
Power LED To be lit when power is supplied from the Finisher to
the downloader PCB
RS-232C cable A cable to connect the downloader PCB and a PC.Be
(straight full wiring; 9 sure to connect the cable in a way that its ferrite core
pins) comes to the PC side.
Cable A (9 pins) A cable to connect the downloader PCB and other
Length: approx. 70cm products
Cable B (9 A cable to connect the downloader PCB and the
pins)Length: approx. Finisher
50cm
RS-232C connector A connector to connect an RS-232C cable to the
downloader PCB
[1] [2] [3] [4]
F-4-51
T-4-23
[7] [6]