Removing The Tray Guide Cover - Canon Inner Finisher-K1 Service Manual

2. When installing the Stack Tray, check that the 2
Claws [2] and 2 Hooks [3] of the Stack Tray [1] is
properly installed. If the installation fails, error;
E540-8001/8002 may occur at power ON.
[1]
[2]
[2]
[2]
Removing the Tray Guide
Cover
■ Preparation
1. Remove this machine from the host machine.
"Removing this Machine" on page 44
2. Remove the Front Cover
Cover Unit" on page 51
3. Remove the Rear Cover."Removing the Rear Cover"
on page 51
4. Remove the Delivery
Tray" on page 51
5. Remove the Upper Feed
Upper Feed Guide Unit" on page 55
[3]
[3]
[3]
Unit."Removing the Front
Tray."Removing the Delivery
Guide."Removing the
4. Parts Replacement and Cleaning
■ Procedure
1. Remove the Upper Stay [1].
• 2 Screws [2]
2x
2. Move the Front Alignment Plate [1] and Rear
Alignment Plate [2] to the slit [3] of the Tray Guide
Cover.
3. Release the latch [1] and move the Front/Rear Tray
Plate [2] to the bottom.
[2]
4. Remove the Tray Guide Cover [1].
• 2 Screws [2]
• 2 Claws [3]
53
[2]
[1]
[1]
[2]
[3] [3]
[2] [1]