E5F6;Paper Pushing Plate Motor Error; E5F9;Micro Switch Error - Canon Saddle Finisher-T2 Service Manual

Chapter 4
Stitcher motor (front) (M7) / Saddle sticher controller PCB
3) Does it improve when the stitcher is replaced?
YES : End
NO : Replace the saddle stitcher controller PCB.

4.4.1.19 E5F6;Paper pushing plate motor error

Paper pushing plate home position sensor (PI14)/Paper pushing plate top position sensor (PI15)/Paper
pushing plate motor clock sensor (PI1)
1) Check the sensors. Do the sensors operate normally?
NO : Replace the sensors.
Paper pushing plate drive mechanism
2) Is there any abnormality in the paper pushing plate drive mechanism?
YES : Repair the paper pushing plate drive mechanism.
Paper pushing plate motor (M8)/Saddle stitcher controller PCB
3) Does it improve when the paper pushing plate motor is replaced?
YES : End
NO : Replace the saddle stitcher controller PCB.

4.4.1.20 E5F9;Micro switch error

Front cover switch (MSW101)/Inlet door switch (MSW1)/Delivery door switch (MSW3)
1) Check the switches. Do the switches operate normally?
NO : Replace the switches.
Power supply and wiring
2) Measure the voltage between J704-1 (+) and J704-3 (-) of the finisher controller PCB. Is the voltage 24V?
NO : Replace the finisher controller PCB.
3) Is the wiring between J704 of the finisher controller PCB and J1 of the saddle stitcher controller normal?
NO : Repair the wiring.
YES : Replace the saddle stitcher controller PCB.
4-18
0009-2608
0009-2610