Canon Saddle Finisher-T2 Service Manual page 59

3) The alignment plates escape to points 10 mm from the edge of the stack.
4) When the following stack arrives, steps 1 through 3 above are repeated.
5) The alignment plates butt against the stack once again, during which stitching takes place.
6) The alignment plates escape to points 10 mm from the edges of the stack, after which folding and delivery take
place.
7) When the first sheet of the following stack reaches the No.1 paper sensor, the guide moves to a point 10 mm from
the edge of the stack to be ready for the next alignment operation.
F-2-32
F-2-33
F-2-34
F-2-35
Chapter 2
2-27