Canon Saddle Finisher-T2 Service Manual page 226

Chapter 4
F-4-41
b. Connection to the Finisher
1) Turn off the power of the host machine.
2) Remove the rear upper cover of the Finisher.
3) Insert the cable B to J723 on the Finisher controller PCB.
4) Connect the RS-232C cable to the RS-232C connectors of the circuit board and the PC.
5) Turn on the power of the host machine.
c. Download
The error code E713 might occur during download. It does not affect the download operation and its results.
1) Start up the Service Support Tool.
C:\ProgramFiles\Service Support Tool\bpchost.exe
2) Select the type of host machine.
4-40