Removing The Tray 2 - Canon Saddle Finisher-T2 Service Manual

Chapter 3
[2]
F-3-12
2) Remove the screw [1] and remove the stopper [2] at
the back.
[1]
F-3-13
3) Remove two screws [1], open three harness
retainers [2], and disconnect two connectors [3].
[3]
[3]
F-3-14
4) Lift tray 1 [1] to remove it.
3-4
[1]
[2]
[1]
[2]
[1]
[2]
[1]
F-3-15
When installing the tray, be careful not to twist the
tray cable. To prevent the gear phase from shifting
due to the front and rear rails, the tray must be
attached horizontally. Lower the tray [1] to the
position shown in the figure and compare the
heights of the shutter guide top edges [2] with those
of the tray projections [3] at the front and rear to
check that the tray is attached horizontally. If their
heights are not the same, remove the tray and then
attach it again.
[2]
[1]
F-3-16

3.1.4.7 Removing the Tray 2

When moving the tray down to attach it, you need
[3]
0009-3625