Canon Saddle Finisher-T2 Service Manual page 91

Jam Type Sensor
Inlet delay PI22
Inlet PI22
stationary
Feeding PI18
delay
Feeding PI18,PI19,
stationary PI20
Delivery PI11
delay
Delivery PI11,PI17
stationary
Stitcher SW7,SW5
staple
T-2-13
Jam Condition
When the saddle inlet sensor (PI22) does not
detect paper after a prescribed time (distance)
has elapsed since receiving a saddle delivery
request from the Finisher.
When paper does not exit the saddle inlet sensor
(PI22) after feeding for a prescribed amount with
the feed motor (M1) after the saddle inlet sensor
(PI22) detected the leading edge of the paper.
When the 1st paper sensor (PI18) does not detect
paper after prescribed time (distance) has
elapsed since the saddle inlet sensor (PI22)
detected the leading edge of the paper.
When paper does not exit the 1st paper sensor
(PI18), 2nd paper sensor (PI19), and 3rd paper
sensor (PI20) after feeding for a prescribed
amount with the feed motor (M1) after the 1st
paper sensor (PI18) has detected the leading
edge of the paper.
When delivery sensor (PI11) cannot detect the
paper after feeding the stack for a prescribed
amount with the paper folding motor (M2) after
completing paper pushing motion with the paper
pushing plate.
When stack does not exit the delivery sensor
(PI11) after feeding the stack for a prescribed
amount with the paper folding motor (M2) after
detecting the leading edge of the paper with the
delivery sensor (PI11).
When stack does not exit the vertical path paper
sensor (PI17) after feeding the stack for a
prescribed amount with the paper folding motor
(M2) after detecting the stack with the delivery
sensor (PI11).
When stitch motors (M7/M6) are rotated
forward and the stitch home position sensors
(SW7/SW5) do not turn ON within 0.4 seconds
after they are turned OFF and the motors are
rotated backward and the sensors turn ON within
0.4 seconds.
Code
1793
17A3
1791
17A1
1792
17A2
1786