Canon Saddle Finisher-T2 Service Manual page 168

Chapter 3
[1]
[3]
F-3-267
6) Remove the two C-rings [1] at the rear, and remove
the sensor flag [2] and two bearings [3].
[1]
F-3-268
7) Remove the two C-rings [1] at the front and remove
the two gears [2].
[1]
F-3-269
8) Remove the two bearings [1].
3-66
[2]
[4]
[3]
[2]
[2]
F-3-270
9) Open the saddle delivery tray [1].
10) Remove two screws [2] and remove the two
aligning plates [3].
11) Slide the two paper folding rollers [4] to the front,
and then pull it out in the delivery direction.
[2]
F-3-271
When installing, attach the gear [2] so that the
grooves [1] of the paper folding rollers face each
other and align the phase.
[2]
F-3-272
[1]
[4]
[2]
[3]
[1]
[1]