Removing The Swing Unit - Canon Saddle Finisher-T2 Service Manual

Chapter 3
4) Remove four screws [3] and remove the finisher
controller PCB [4].
[1]
[3]
F-3-59
5) Release the claw [1] of the stack delivery roller rear
side clutch [2] and remove the clutch [2].
6) Remove the E ring [3], washer [4], and bearing [5]
and remove the stack delivery roller.
[3] [4] [5]
F-3-60
7) Disconnect two connectors [1] and remove harness
from the clamp and edge saddle [2].
8) Remove two screws [3] and pull out the processing
tray [4] in the paper delivery direction.
When removing parts inside the processing tray,
be careful not to exert force on the aligning plate
(front/rear) or the rear end stopper plate.
3-16
[2]
[4]
[2]
[3]
[1]
[2]
F-3-61
3.2.2.10 Removing the Swing
Unit
1)Remove two screws [1] and remove the solenoid
cover [2].
F-3-62
2) Remove screw [1] and pull up the swing pressure
guide [2].
F-3-63
0009-3658