Removing The Swing Unit Static Charge Eliminator; Static Charge Eliminator 2; Removing The Inlet Static Charge Eliminator - Canon Finisher-R1 Service Manual

F-4-184
4.4.2.10 Removing the Swing
Unit Static Charge Eliminator
1) Remove the screw [1] securing the static charge
eliminator at the center of the swing unit.
2) Remove two screws [2] securing the ground of the
delivery side static charge eliminator.
F-4-185
3) Pull out the static charge eliminator at the center of
the swing unit from the bottom.
4) Remove the four claws [4] securing the delivery
side static charge eliminator and remove the two static
charge eliminators [5].
0004-4711

4.4.3 Static Charge Eliminator 2

4.4.3.1 Removing the Inlet
Static Charge Eliminator
1) Open the upper door and unhook the hook linking
the upper door and inlet upper guide.
2) Remove three screws [1] and remove the inlet static
charge eliminator [2].
Chapter 4
F-4-186
0004-4713
F-4-187
4-53