Set The Storage And Load System - Tenma 72-7910 Manual

Types (F1)
Format
(F2)
Persist (F3)
Waveform
Brightness
(@)
X Y Mode
Users can enter the X‐Y mode by pressing Display button and select F2. In this mode,
CH1 and CH2 are required to be applied simultaneously. The figure below shows an
example for the X‐Y mode display.
Attention:
The following functions will be disabled at X Y display mode.
Automatic measurement
Cursor measurement
6. Set the Storage and Load System
Vector
Dots
YT
X Y
Off
1s
2s
5s
Infinite
1 % ‐
100%
Figure 2‐21 Waveform Display in X Y Mode
40
Model 72‐7610/72‐10510 User Manual
Display as vector of sampling points
Display any of the sampling points
Display Y‐axis as voltage level of input
signal and X‐axis as time
Display Y‐axis as CH2 voltage level of
input signal and X‐axis as CH1 voltage
level of input signal
Real‐time updating (Display) of the
acquired signal.
Display the acquired signal every 1s
Display the acquired signal every 2s
Display the acquired signal every 5s
Accumulate to display all the
acquired
Set waveform brightness by
multi‐purpose knob from 1% to
100%.