info@Testo-Direct.com
6 Using the product
[Options]
>
→
a measurement) Disable/enable alarm signal.
>
[Options]
→
>
[Options]
→
detected.
2. End detection:
6.3.
Transferring data
6.3.1.
Report printer
To be able to transmit data via infrared or Bluetooth interface to a
Testo report printer, the printer to be used must have been
activated, see Printer, page 40.
Printing out data takes place via
available if a printout is possible.
Representation of the available characters per line is
limited on the printout. Thus, the unit
displayed on the printout as mg/k.
6.3.2.
PC / Pocket PC
Data transfer to a PC can take place via USB, IrDA or Bluetooth
You must also refer to the documentation that comes with the
software.
58
www.
Alarm
signal: (this function is not available during
Zeroing
probe: perform zeroing.
Sensor
detection: newly inserted sensor is
[
].
[Print]
[
]. The function is only
or
mg/KWh
Testo-Direct
is
®
.
1.888.610.7664
.com