info@Testo-Direct.com
6 Using the product
Showing the flue gas matrix
This function is only available if the measurement parameter
has been activated in the measured value display.
Call up function:
✓ The flue gas function is open.
>
[Options]
→
Options
[Options]
→ Clipboard: data is saved to the clipboard.
>
>
[Options]
→
is deleted.
>
[Options]
→ Save: the measured values are saved in a record.
>
[Options]
→
numerical values.
>
[Options]
→
during a measurement) Set the system type to be able to
configure the ideal zone (green) of the flue gas matrix, using the
limits pre-configured for each system type.
>
[Options]
→
deleted.
>
[Options]
→ Thresholds: (This function is not available during
a measurement) Enter limits to be able to configure the ideal
zone (green) of the flue gas matrix.
>
[Options]
→
should be assigned to the x-axis of the display matrix (O2 or
CO2).
>
[Options]
→
during a measurement) Open the measured value display
menu.
3.
6.2.3.
Draught measurement
Call up function:
✓ A flue gas probe must be connected.
1.
[
]
→
Measurement options
Carrying out the measurement:
During the zeroing phase, the flue gas probe must be
outside the flue gas duct.
Do not measure for longer than 5 min, as a drift of the
pressure sensor means that the measured values may be
outside the tolerance limits.
48
www.
Fluegas
matrix.
Delete
clipboard: any data saved to the clipboard
Show numeric
value: data is displayed as
System
type: (This function is not available
Reset
graphic: the displayed graphical values are
CO + O2
or
CO +
CO2: choose which parameter
Measurement
view: (This function is not available
→
[OK]
→
Testo-Direct
CO
Draught
→ [OK].
1.888.610.7664
.com