Oil Flow; Ambient Co - TESTO 320 Instruction Manual

info@Testo-Direct.com
Options:
> [Options] → Clipboard: data is saved to the clipboard.
> [Options] →
is deleted.
> [Options] → Save: the measured values are saved in a record.
> [Options] →
[Options]
> →
> [Options] →
duration and GasPgr can be changed.
6.2.13.

Oil flow

The function is only available if the chosen fuel is an oil.
Calling up the function:
[ ] Measurements
> →
Performing the measurement:
1. Select the parameters
Pressure (no effect on calculation): [▲],
2. Enter values. [▲],
- The calculated oil burner capacity (in kW) is displayed.
Options:
> [Options] → Clipboard: Data are saved to the clipboard
[Options]
> →
is deleted.
> [Options] → Save: The readings are saved in a protocol.
> [Options] →
changed (kg/h > gal/h
6.2.14.

Ambient CO

This function is not available when the
selected.
✓ A flue gas probe must be connected.
CO ambient measurement cannot be done with the external
CO ambient probe.
Cigarette smoke influences the measurement by more than
50 ppm. The breath of a smoker influences the
measurement by about 5 ppm.
When using an ambient CO probe, note that:
The direction of flow of the gas has an effect on the
accuracy of measurement. Frontal flow onto the probe
www.
Delete clipboard: any data saved to the clipboard
Enter Gas Flow: set the gas flow value.
Enter heating value: heating value can be set.
Units setting: the unit for gas flow, heating value,
[OK] Oil Flow
→ →
Oil Flow (of the oil nozzle) and
[▼]
[▼] and partly [◄], [►]→ [OK].
Delete clipboard: Any data saved to the clipboard
Unit settings: The unit for the oil flow can be
or gal/h > kg/h).
Spain country version is
Testo-Direct
6 Using the product
→ [OK].
Oil
→ [Edit].
55
1.888.610.7664
.com