Bimschv - TESTO 320 Instruction Manual

info@Testo-Direct.com
6 Using the product
Options:
> [Options] → Recalibrate: the gas sensors are set to zero.
> [Options] → Addresse/Location: the Address/Location folder
is opened.
> [Options] → Fuels: select fuel.
> [Options] →
changed, start sensor detection manually.
To calculate the average, a series of 3 measurements are carried
out.
Averaging:
1. Position the flue gas probe in the centre of flow (area of the
highest flue gas temperature).
2. Start measurements
> First measurement:
> Second and third measurement:
- The set measurement parameters, measurement period and
measured values are displayed.
- A signal is sounded after 2 min (recommended measurement
period)
3. End measurements:
- Once the series of measurements has been carried out, the
record for averaging is displayed.
> If necessary, scroll through the record: [◄],
4. [Next]
5. Enter checks:
> Select criterion: [▲], [▼].
> Change value:
[Close]
6. End check:
- The record is saved.
7.
6.2.6.

BImSchV

This function is only available when the
is selected.
A qA average value measurement can be carried out. For this
purpose the average is determined continuously over a period of 30
s, the measuring cycle takes 1 s. The average values actually valid
at the corresponding time of recording are displayed.
Call up function:
✓ A flue gas probe and a combustion air temperature probe must
be connected.
50
www.
Sensor detection: once the probe has been
[ ].
[OK]
[ ].
[Edit] → [▲], [▼] → [OK].
Germany
Testo-Direct
[►]
country version
1.888.610.7664
.com