Westermo RedFox Series Management Manual page 731

Use "show default-cost" to show the setting of the default-cost, i.e., the
cost of the default route injected by ABRs into a stub or NSSA area.
Default values "default-cost 0"
28.3.13 Configure inter-area route summarisation and filtering
Syntax [no] range <NETWORK/LEN> [<advertise|not-advertise]
Context OSPF Area Configuration
Usage Configure inter-area route summarisation or route filtering.
Use the "range <NETWORK/LEN>" ("range <NETWORK/LEN> advertise" is
equivalent) to aggregate routes (within this area) matching the specified
<NETWORK/LEN> range, before distributing the routes outside this area.
That is, all routes within this range are summarised as a single route, when
advertised outside this area.
Use the "range <NETWORK/LEN> not-advertise" to prohibit routes (within
this area) matching the specified <NETWORK/LEN> range, to be distributed
outside this area. That is, routes within this range are filtered.
Use "no range <NETWORK/LEN>" to remove a specific summary/filter set-
ting, or "no range" to remove all summary/filter settings for this area.
Use "show default-cost" to show configured route summarisation and
route filtering settings for this area.
Default values Disabled
28.3.14 Manage Interface Specific OSPF Settings
Syntax [no] ospf
Context
Interface Configuration
Usage Enter the Interface OSPF Configuration context, i.e., the context where
Interface specific OSPF settings are configured.
Use "no ospf" to remove any specific OSPF settings for this interface.
© 2018 Westermo Teleindustri AB
Westermo OS Management Guide
context
context
Version 4.24.1-0
731