Westermo RedFox Series Management Manual page 1029

If parameter is applicable in a certain mode is denoted with a character according
to:
ˆ S - TCP-Server
ˆ C - TCP-Client
ˆ P - Peer (UDP)
ˆ A - AT Command
Enabled
Mode
Protocol
Extensions
DTR Control
Serial Port
AT Command
Profile
Frame separator
Frame size
Frame delay
Listen (local end)
Secondary
Listen Port
Secondary Mode
Secondary
Mode Timeout
Multicast group
Dynamic peer
© 2018 Westermo Teleindustri AB
All Check the box to enable the Serial Over IP in-
stance, uncheck to disable. If disabled, the in-
stance will not be started.
All Set operating mode: Server (TCP), Client (TCP),
Peer (UDP), or AT Command.
S Disable or chose appropriate protocol extension.
S,C,A Enable DTR control on the connection.
All Serial port to use.
A Select a command profile for this AT command in-
stance. See
All Enable/Disable and define frame separator char-
acter if enabled.
All Define maximum frame size in characters.
All Define maximum frame delay in milliseconds.
S, P The interface to accept incoming Serial Over IP
traffic, and the TCP/UDP port to listen to. Default
Interface: Any. Default port: 9000
S Additional local TCP port to listen to. Will listen
on the same interface as set in Listen option. De-
fault: Disabled (empty)
S How to handle concurrent access to serial port.
See Section 40.1.2
Slotted
S Timeout for Secondary mode slotted. Default:
600 ms
P Multicast address to listen to.
P Enable/disable dynamic peer
Westermo OS Management Guide
Section 40.1.5 for more information.
for available modes. Default:
1
Continued on next page
Version 4.24.1-0
.
1029