Westermo RedFox Series Management Manual page 1104

Hide thumbs Also See for RedFox Series:

Table of Contents

TTDP Conﬁguration

Usage Conﬁgure IEC61375 multicast routes.

For custom routes, <MCADDR> may be inside the RFC 2365 "organization

scope" range (239.192.0.0/14), but must not be inside the IEC 61375-2-

5 reserved range (239.192.0.0/24). The speciﬁed group will be routed to

<NET_ID> from every other connected ECN as well as from the local ETB.

Currently this setting needs to be conﬁgured on all the potential source

and receiver ETBNs.

<NET_ID> can be a numeric ECN ID or the special value "etb", which maps

to the ETB interface. In that case the group will be routed from all local CNs

Example (assuming local ECNs 1,2,3):

example:/#> conﬁgure

example:/config/#> ttdp

example:/config/ttdp/#> mroute group 239.192.1.1 out 1,2,etb

will set up the following routes for 239.192.1.1:

-> ECN 1, ECN 2

ECN 1 -> ECN 2, ETB

ECN 2 -> ECN 1, ETB

ECN 3 -> ECN 1, ECN 2, ETB

Use "no mroute" to remove all conﬁgured multicast routes.

Use "show mroute" to view the current multicast routes handled by TTDP.

Default values Not applicable

43.2.12 Show topology status

Syntax show ttdp conn

Westermo OS Management Guide

Version 4.24.1-0