On this page you can change the settings for the serial port.
Type
Type
Speed
Data bits
Parity
Stop bits
HW flow control
SW flow control
Termination
© 2018 Westermo Teleindustri AB
Enable/disable the serial port by checking/unchecking
this checkbox.
Select serial interface type. Selections only available if
multiple interface types are supported by hardware.
Set serial port data rate.
Set the number of data bits
Set parity error detection
Set the number of stop bits
Enable/disable hardware flow control using RTS/CTS
Enable/disable software flow control using XON/XOFF
Select serial interface termination for RS422 and
RS485.
Westermo OS Management Guide
Version 4.24.1-0
1007