Westermo RedFox Series Management Manual page 1094

For more information regarding VRRP configuration in WeOS, please see
ter 31.
Example
example:/#> configure
example:/config/#> router
example:/config/router/#> vrrp 1
Creating new vrrp instance: 1
Invalid settings: Interface not set.
example:/config/router/vrrp-1/#> iface vlan1
Invalid settings: Invalid IPv4 address.
example:/config/router/vrrp-1/#> address 10.0.0.129
Invalid settings: VRID invalid. Valid values: 1 to 255.
example:/config/router/vrrp-1/#> vrid 1
example:/config/router/vrrp-1/#> version 3
example:/config/router/vrrp-1/#> interval 200 msec
example:/config/router/vrrp-1/#> priority 120
example:/config/router/vrrp-1/#> preempt delay 2
example:/config/router/vrrp-1/#> end
example:/config/router/#> vrrp 2
Creating new vrrp instance: 2
Invalid settings: Interface not set.
example:/config/router/vrrp-2/#> iface vlan100
Invalid settings: Invalid IPv4 address.
example:/config/router/vrrp-2/#> address ttdp
Invalid settings: VRID invalid. Valid values: 1 to 255.
example:/config/router/vrrp-2/#> vrid 2
example:/config/router/vrrp-2/#> version 3
example:/config/router/vrrp-2/#> interval 200 msec
example:/config/router/vrrp-2/#> priority 120
example:/config/router/vrrp-2/#> preempt delay 2
example:/config/router/vrrp-2/#> sync 1
example:/config/router/vrrp-2/#> leave
Configuration activated.
example:/#>
43.1.3.6 Multicast routes
The configuration steps conducted so far would suffice if you only wish to route
IP unicast packets through the ETBNs. To also route IP multicast some additional
configuration steps are required in the ETBNs. To illustrate the configuration, two
similar consists are used as shown in
ˆ Multicast forwarding: IP multicast forwarding must be enabled on all ETBNs
(chapter 30).
1094
Remember "copy run start" to save to flash (NVRAM).
fig.
Westermo OS Management Guide
43.5.
© 2018 Westermo Teleindustri AB
Version 4.24.1-0
chap-