Westermo RedFox Series Management Manual page 1090

Example
example:/#> configure
example:/config/#> iface vlan100
example:/config/iface-vlan100/#> inet ttdp
example:/config/iface-vlan100/#> enable always
example:/config/iface-vlan100/#> distance 1
example:/config/iface-vlan100/#> end
example:/config/#>
The IP address for the ECN interface (here vlan1) is typically an address in the
10.0.0.0/18 range. That is, WeOS ETBNs assume that "local" subnets are used
within the ECN, and TTDP will automatically assign NAT rules (R-NAT) to map
between the local subnet and the train wide subnet assigned to the ECN by TTDP
(see also "consist-net" setting in
is assigned address "10.0.0.1/18" on its ECN interface. (If you have a second
ETBN in your ECN, you could give that unit, e.g., address "10.0.0.2/18" on its
ECN interface.)
Before configuring vlan1, existing addresses (if any) are removed and the address
method is set to "inet static".
Example
example:/config/#> iface vlan1
example:/config/iface-vlan1/#> no address
example:/config/iface-vlan1/#> inet static
example:/config/iface-vlan1/#> address 10.0.0.1/18
example:/config/iface-vlan1/#> distance 2
example:/config/iface-vlan1/#> end
The interface vlan492 is used for TTDP signalling. This interface should be con-
figured as always up and without IP address. In future releases of WeOS, this
explicit configuration of interface vlan492 may not be necessary.
Example
example:/config/#> iface vlan492
example:/config/iface-vlan492/#> inet static
example:/config/iface-vlan492/#> enable always
example:/config/iface-vlan492/#> no address
example:/config/iface-vlan492/#> no management
example:/config/iface-vlan492/#> leave
Configuration activated.
example:/#>
1090
section
Remember "copy run start" to save to flash (NVRAM).
Westermo OS Management Guide
43.1.3.4). In this example, the ETBN
© 2018 Westermo Teleindustri AB
Version 4.24.1-0