Westermo RedFox Series Management Manual page 1016

Feature
Select Serial Port
Addressing/Port Settings
Receiving (incl. multicast)
Sending (incl. multicast)
Modem Replacement /
AT command interpreter
Priority
40.1.1 Serial Over IP introduction
The Serial Over IP application can be used in several ways, but the use cases can
be divided into four typical applications:
ˆ Serial point-to-point
ˆ Serial one-to-many (typically a Master-slaves application)
ˆ PC access to remote serial devices.
ˆ Modem replacement
40.1.1.1 Point-to-point
In this way two serial devices can communicate over an IP network. It can be set
up either as a client-server configuration using TCP, and as two peers using UDP.
Serial
Device
40.1.1.2 One-to-many
This allows one serial device (typically a master) to communicate with multiple
serial devices using UDP transport. It can be set up as IP broadcast, IP multicast,
1016
Web
X
X
X
X
X
TCP-
server or
UDP Peer
Figure 40.1: Serial Point-to-point link
Westermo OS Management Guide
Continued from previous page
CLI General Description
X Section 40.1.2
X -"-
X -"-
X -"-
X Sections 40.1.1.4
Sections 40.1.4
X Sections 40.3.7
Network
© 2018 Westermo Teleindustri AB
Version 4.24.1-0
and 40.1.2,
and 40.1.5
TCP-client
or UDP
Device
Peer
Serial