Table of Contents
Advertisement
Context
Serial Over IP Configuration
Usage Multicast group to listen on. Note, this is only used in peer mode.
Use "show mcast-group" to show the current setting.
Default values Disabled ("no mcast-group")
40.3.15 Enabling Dynamic-peer
Syntax [no] dynamic-peer
Context
Serial Over IP Configuration
Usage Enable/disable dynamic-peer (The "dynamic peer" setting is referred to
as "latest calling" in Westermo EDW-100.)
Use "show dynamic-peer" to show the current setting.
Default values Disabled
40.3.16 Setting AT Command Set
Syntax [no] atcmd-set <ID>
Context
Serial Over IP Configuration
Usage Select AT command set. This setting is only valid when Serial Over IP is
configured in AT command mode, see
Use "atcmd-set <ID>" to select an AT command set. AT command sets
are created via the "atcmd <ID>" command, see
command set identifier (ID) can take values in range 1-5.)
Use "no atcmd-set" to remove (disable) an AT command set selection.
Use "show atcmd-set" to show the current setting.
Default values Disabled ("no atcmd-set")
40.3.17 Managing AT Command Profiles
Syntax [no] atcmd [ID]
© 2018 Westermo Teleindustri AB
Westermo OS Management Guide
context
context
context
section
40.3.2.
Version 4.24.1-0
section
40.3.17. (The AT
1041
Advertisement
Table of Contents
