Westermo RedFox Series Management Manual page 1088

your aggregates with ports X9-X10, and ports X11-X12 respectively.
Example
example:/#> configure
example:/config/#> aggregate a1
Creating new aggregate a1
a1: Invalid settings: No ports defined for aggregate.
example:/config/aggregate-a1/#> ports x9-x10
example:/config/aggregate-a1/#> mode static
example:/config/aggregate-a1/#> end
example:/config/#> aggregate a2
Creating new aggregate a2
a2: Invalid settings: No ports defined for aggregate.
example:/config/aggregate-a2/#> ports x11-x12
example:/config/aggregate-a1/#> mode static
example:/config/aggregate-a2/#> leave
Configuration activated.
example:/#>
43.1.3.2 Backbone and Consist VLANs
Next you create VLANs for the train backbone (ETB) and consist network (ECN)
ports. In this example we assume VLAN 1 (default VLAN) is used for the ECN and
VLAN 100 for the ETB. As of WeOS v4.24.1 you need to create an additional VLAN
(VLAN 492) for TTDP signalling on the backbone ports (this requirement may go
away in future releases of WeOS).
First we configure the ETB VLAN (here VLAN 100). The IEC 61375 standard man-
dates that IGMP snooping is disabled on the ETB. Data is sent untagged. Naming
the ETB VLAN "etb" is only for documentation purposes, thus can be skipped.
Example
example:/#> configure
example:/config/#> vlan 100
Creating new VLAN vid:100 with name: vlan100
example:/config/vlan-100/#> untagged x9-x12
Moving untagged port Eth X9 from vid 1 to vid 100.
Moving untagged port Eth X10 from vid 1 to vid 100.
Moving untagged port Eth X11 from vid 1 to vid 100.
Moving untagged port Eth X12 from vid 1 to vid 100.
example:/config/vlan-100/#> no igmp
example:/config/vlan-100/#> name etb
example:/config/vlan-100/#> end
example:/config/#>
1088
Remember "copy run start" to save to flash (NVRAM).
Westermo OS Management Guide
© 2018 Westermo Teleindustri AB
Version 4.24.1-0